Kerosene lamps are recommended to keep at home, at time of an eventual crisis.

Source: Civilförsvarsförbundet 

Material: Glass 

Colour: Transparent, Brass

Size: Ø 8 x H 18 cm

The kerosene lamp must be switched off and cold when filling.

- Remove the burner glass and unscrew the burner.
- Fill the lamp with lamp oil, circa 2/3. Use a funnel for minor spills.
- Put the burner with wick back and let the wick absorb lamp oil for approx 20-30 minutes.
- Light the lamp and adjust the height of the flame with the screw on the side of the burner.
- Put back the burner glass.

Please do note that you may have to adjust the burner glass in order to get it straight. When the glass is straight, use the metal clamps on the burner to stabilize it. 

To turn off the light:
Extinguish the flame by slowly lowering the wick until the flame goes out or blow out the flame.

Shift wick:
The old wick is pulled out from the burner from below and the new one is inserted from below and screwed up to the correct height.

Important:
The burner glass will be extremely hot when the lamp has been burning for some time. Place the lamp on a flat surface away from flamable material. Make sure to also keep the area above the lamp, about 1 meter, free.

Consider the lamp as a primary light source and not only as decoration. Never leave the lamp unattended and keep it out of reach of children and pets. The lamp oil is very toxic to ingest. If swallowed DO NOT induce vomiting but contact poison control centre for guidance.

(Please read the inclosed directions for use before using the lamp)

Funnel Size: Ø 7 x H 11 cm

Strömshaga's own high quality lamp oil! The lamp oil provides a stable and soot-free flame and is completely clean and clear. The oil is made of n-paraffins and is recommended for kerosene lamps and kerosene stoves.

Instructions for use: Fill the kerosene lamp, kerosene kitchen or stove, preferably with a funnel. NOTE! The kerosene lamp or stove must be extinguished and cold when refilling.

Instructions for use of kerosene lamp: Remove the burner glass and unscrew the burner, then fill the lamp with approx. 2/3 lamp oil. The first time you fill your kerosene lamp or after you've change the wick, let the wick soak for about 20-30 minutes before lightning the lamp for a smooth flame.

Make sure that the wick have a straight cut at the top and to not have a too long visible wick. Light the wick with matches or a lighter and then immediately adjust the flame with the knob on the burner. Then put back the burner glass.

Dosage: Used as a concentrate.

Important: Store the bottle out of reach and sight of children. Remember to screw on the cap securely after use. Keep the kerosene lamp out of the reach of children and away from pets. This also applies to the lamp when it is not lit. 

The lamp oil may be fatal if swallowed and enters airways. IF SWALLOWED: Do NOT induce vomiting. Contact Poisons Centre and doctor immediately. Repeated exposure may cause skin dryness or cracking. In case of skin contact, remove contaminated clothes and wash your skin with soap and water.

Leave the content / bottle to a recycling center.